All parts were printed on a P1S 3d printer.

In addition to the top and base, you will need to print 10 foil pieces.

Print Settings:

Infill:  0% for each foil.  5% for the base and top

Infill Pattern:  Gyroid.

Layer Height:  .2mm for the base and top.  .1mm for each foil.

Supports:  Supports are only needed for the base.

I recommend decreasing your top surface line width to about .38 when printing each foil part to get a cleaner surface.

You will also need to purchase a Remote Control RGB LED Lamp Kit 001. You can find these on Amazon.com https://www.amazon.com/dp/B0F18V1LWH?ref=ppx_yo2ov_dt_b_fed_asin_title