This is a screwdriver rack made for one of these (https://www.amazon.co.uk/gp/product/B00JITIPFG You may need to copy-paste the link)

I've attached a standalone desktop version and a pegboard mount that fits this (https://www.amazon.co.uk/gp/product/B01CIE27LU You may need to copy-paste the link) pegboard.

The files to print each are as follows:
Desktop version:

• 1 x Top rack. Print with flat side down, no supports
• 1 x Bottom rack. Print with flat side down, no supports
• 4 x desktop-support. Print laying down, no supports

Pegboard Version:

• 1 x Top rack. Print with flat side down, no supports
• 1 x Bottom rack. Print with flat side down, no supports
• 4 x pegboard-support. Print laying down, no supports
• 4 x pegboard-clip on attachment. Print with circle pegs facing up. no support needed, the gap in the middle will bridge fine.

If you have any changes you think I should make, please let me know!