this was made from an internet image using hue forge

here are the steps….

Project: this.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x119.5mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

Filaments Used:
#080a0d PLA PolyLite Black  Transmission Distance: 0.3
#4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
#8c9099 PLA PolyLite Grey  Transmission Distance: 1
#ff7713 PLA+ Sunlu Sunny Orange  Transmission Distance: 7.1
#e2dedb PLA PolyLite White  Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
Start with PolyLite Black
At layer #8 (0.72mm) swap to BambuLab Basic Blue Gray
At layer #12 (1.04mm) swap to PolyLite Grey
At layer #13 (1.12mm) swap to Sunlu Sunny Orange
At layer #14 (1.2mm) swap to PolyLite White for the rest.