A set of risers for stacking miniatures in layers with my iStor Hexi system

Different sized risers are provided for choosing between clearance heights. Be sure to use risers of the same height. They have dot markings to help differentiate between the sizes, but the height difference should be fairly obvious.

Creality

Ender 3

Doesn't Matter

Doesn't Matter

0.2mm

10% gyroid

Each riser pillar/post will need two of the same corresponding plates and two latches.

The pillars and latches for placing on the left and right sides are identical as are those for top and bottom. Plates, however, have four separate versions: left, right, top, and bottom.

The plates slide in from the outside direction on the pillars, and will be held in place once connected to the hexes with borders. Optionally they could be secured with a drop of glue.

Open the bottom latches so that they do not protrude past the inner edges of the bottom of the pillars

Make sure the riser plates are pushed all the way tight towards the center

Lower the bottom layer of hexes + edges down onto the pegs on the riser plates.

Once the hex layer is seated, secure the latches to lock it into place.

Repeat the procedure for the top layer of hexes.

Note that if the top plates are not secured to the pillars with some form of glue they might need to be held in place while seating the hexes.