This is a forward-swept wing jet fighter concept, inspired by YF-19, Su-47, and X-29.

For my print I set the layer height or resolution to 0.08 mm. I suggest setting the layer height as thin as possible, because the canard is very thin, so if the layer height is thick like 0.2 mm. The canard will be weak and easy to snap off.

The recommended Cura support placement setting is “Touching Buildplate” or check the "Support on build plate only" in PrusaSlicer. Using this setting means there will be no support structure in between the model. Therefore you will only have to clean up the supports that hold the wing and fuselage.

Enjoy!