A propeller guard I designed as a spare for my Visuo XS809 drone.
PropGuardVase printed in vase mode (Slic3r), 0.2mm layer height, 3 bottom layers, external_perimeter_extrusion_width = 0.7mm
You will need two of them, mirrored.
Guard printed in vase mode (Slic3r), 0.2mm layer height, 3 bottom layers, external_perimeter_extrusion_width = 0.7mm
The lock should be printed in this orientation for the tongue to be flexible enough and dont break. I sliced it with IceSL for easy and clean supports.
The four pieces are glued together with some epoxy. I printed this in PLA but if I should print more I would use PETG. You should print and use these in pairs to keep the drone balanced.

Please post your comments, makes,... :)

Tevo Tarantula

No

Yes

0.2

30%