Model of a small ship.
Made in CAD by a child.
The boat floats steadily in fresh water in its normal position (heading up).
Printed in PLA, nozzle 0.4, layer 0.2, 3 walls, tree-like supports, only from the printing table, density 10%.
Advice: do not print in PETG and other plastics in which the supports are difficult to separate from the model.
To print, you need to turn the model over and place it in the “upside down” position, placing the roof of the cabin on the printing table.
ATTENTION:
1. If you do not enable the support function exclusively from the table, it will be very difficult to clear the cabin from supports.
2. if you use simple supports (not tree-like), then the imitation of the wheel in the wheelhouse will not be able to be printed normally, since its first layers will begin to be printed without support, and without support they will hang in the air, that is, they will fall on the roof of the cabin.