Update 11/08/25: Many thanks to user SerialD3, I messed up an updated part. Mid V3.stl should now be the correct one.
Update 12/07/25: Reduced screw hole size on mid v2.stl to 2.79mm for extra screw grip.

Yes, that's right, it is a Raspberry Pi 5 case in the shape of a traditional pie.

It also fits the active cooler and the nvme board with inbuilt storage for 5 micro sd cards too.

I printed all the parts at .28 layer height, 10% rectilinear infill and the bolts and reset switch stood up on the flat wide end with a 5mm brim and a 0.1mm gap so they wouldn't get toppled over. Also take it easy when you first screw the bolts in. Work them back and forth a little especially as they get close to being fully in.

Mmmm... Delicious raspberry pie...

MY PATREON & PATREON SHOP.
https://www.patreon.com/3DFreeman

Thanks for your continued support!

Source for original pie photos: https://www.freepik.com/
Source for the raspberry pi logo: https://www.thingiverse.com/thing:281122
Imported into Blender then edge traced the lines. Many thanks to RockWave :)