https://youtu.be/B807Bngjp00?si=BrfbCIDer5Juaz3R

This is a 3D model specifically designed to host the electronics and signed an M5 Adam Echo for use as a smart speaker. I have included both a blank copy so that the face can be modified as you would like as well as a two modified versions to match what is seen in the video.

The top portion of this figure has a section that should snap fit the electronics portion of the M5 atom echo.

Installation involves removing the M5 Atom Echo from its manufactured case and snap fitting the PCB into the top of the 3D print with the LED facing towards the eyes. You will also want to remove the small speaker and stick it to the rear wall of the 3D print for better audio quality.

Once finished you can follow the linked instructions on how to set up the Voice Assistant through Home Assistant to have a device similar to what is featured in the video.
https://www.home-assistant.io/voice_control/thirteen-usd-voice-remote/

If you wish to add battery power I will include a printing wiring diagram to show how to add the lithium battery and charger using Adafruits boost 1000 charger.

Prusa

i3 MK3

No

Yes

0.30mm Draft

15%

This is best printed upside down to limit the amount of supports needed.