My 20 year old Maytag dishwasher works fine, but a couple of dish-supporting prongs in the bottom dish rack rusted and broke off. Unfortunately, replacement racks are no longer available, and even if they were, they cost about $200. So I designed this prong clip to replace the missing prongs. They can be installed in place of or next to where the original prong was, as shown in the photo.

JGMagic (JG Aurora)

No

Yes

0.2

25%

Definitely do not use PLA! It will soften and deform at dishwasher temperatures. Same with PETG - better, but still softens. ABS is the best choice. I used 90 degree bed temperature and 248 degrees nozzle temperature. I printed on a textured polymer surface.