This is a mount for the E3D v6 hotend and the BLtouch sensor, designed to work on the Solidoodle 2. This was inspired by the mk5 mount by Lawsy and adapted for the BL touch auto-bed tramming sensor.

I printed this with 20% infill, no supports, and in PLA (and it works just fine). I was expecting to have to print it in ABS, but so far, so good. I did lose about 20 mm from the X-axis, but I don't really miss it. In the future, I may try to figure out a way to replace this lost bed volume with a different endstop configuration. I'm open to suggestions.

Print instructions

Licence: Creative Commons - Attribution Category: 3D Printer Parts Print Settings

Printer Brand: Solidoodle

Printer: Solidoodle 2 - Pro

Rafts: No

Supports: No

Resolution: 0.3mm

Infill: 20%