I made this because I did not want to lose any print hight.
I also have a duel Z rod modification, so it had to work with that. https://www.thingiverse.com/thing:3112808

You'll need each part a mirror of each part:

2 M8 or 5/16 rods 27 inches
8 M8 or 5/16 nuts
8 M5 10mm Screws
8 M5 T-Nuts (like the ones that came with the printer)
2 24'' 12 PVC pipe

Print faux springs at 103%
Print on the side and use lots of infill

I updated the left top mount so that the Z axis can run all the way up to the top with the duel Z rod modification.
Tevo Tornado Rear Support Top2 (1)

and remixed a filament guide to work with this setup
https://www.thingiverse.com/thing:3326389

Tevo Tornado

Doesn't Matter

Doesn't Matter

2.0

30