I recently reorganized my small workshop in the basement of my house. I put OSB panels over the workbench to be able to hang some of the tools I most often use.

I designed a few holders that I share here:

• a stand for large screwdrivers with open slots
• a stand for small screwdrivers with closed slots
• a stand for my hammer (I inherited it from my father, it is rather old so I'm not sure it suits modern dimensions)
• a stand for screwdrivers hex bits
• a stand for my measuring tape (to slide-in the belt clip)

Hope it will be useful for some of you.

Prusa

I3 MK3S

No

No

whatever

20%

I chose to print with a resolution of 0.3 because I wanted a fast result. And I don't need those things to be pretty. I chose PETG because it is less brittle than PLA but PLA should work fine too.