This Tesla Charging Cable Organizer keeps your charging cable clean and tidy. No more tangled messes or hunting for cable ends. 3D printed with minimal material, it weighs under 400g while it is strong enough to hold the heavy charging cable.

Usage Instructions: (Do not reference with the photo which I did it incorrectly.)

1. Put the middle part of the cable inside the center poles
2. After putting one side to the center, the end of the cable goes between an inner and an outer pole.
3. Put the other end of the cable inside the outer poles
   Reverse the process when taking the cable out. I usually keep the whole pack in the trunk while I plug both ends. Then I put the cable organizer with the rest of the cable on the floor.

You will need four M3x30 nuts with bolts.

Creality

Ender 3 Pro

No

No

0.2mm layer height

10% Gyroid

My 0.5 nozzle settings
4 bottom layers
7 top layers
3 lines of wall
Infill speed 80mm/s
Wall speed 40mm/s
Outer wall speed 20mm/s
Travel speed 300mm/s
Initial layer speed 20mm/s
Total print time for 3 pieces should be within 21hrs