Simple case for FlySky's new radio receiver! (I printed in clear PLA)

It prints in two parts, and screws together using 2mm tapping screws.

I used 11mm length screws.

Takes about 25 minutes at .2mm resolution

Here's a 100 pack of 2mm screws on Amazon with prime shipping, if you need them ^-^ https://goo.gl/llvQvb

Print Settings

Printer:

Anet A8

Rafts: 

No

Supports:

No

Resolution: 

.2

Infill:

50% with triangular shaped. Though anything should work really.

Notes:

Printed at 50mm/s speed, though 80 worked fine on my test versions
(I made 6 revisions before uploading! xD)

Category: R/C Vehicles