Low profile minimized bow arms for Nerf Crossbolt.
Works with stock elastic band. No supports needed.

Installation

1. Replace stock bow arms with printed ones.
2. Remove locks from the blaster that check if the band has returned.
3. Tie a knot at end of elastic band on both ends.
4. Strech the band, push it through the slot at the top and then release.

(alternatively tie a knot after pushing the band through the slot)

Extra parts from the photo

• Angled foregrip - https://www.thingiverse.com/thing:1531512
• Nerf to Picatinny adapter - https://www.thingiverse.com/thing:2568331
• Minimized mag release - https://www.thingiverse.com/thing:5983670 (my design)

Mendel90

No

No

40%

Use honeycomb infill and translucent filament (such as PETG) to achieve the texture effect shown in images.

To increase friction of printed parts inside of the blaster, you can put few layers of tape as shown below. This way the minimized bow arms won't fall off.