This anglepoise is made for a 12v led bulb running off a 3x 18650 power bank https://www.thingiverse.com/thing:4177805
but i expect it can be adapted for another light with another source.
The shade is superglued to the bulbholder.

Tenlog TL D3 Pro

No

Yes

8%

Petg can be used with the shade and the bulbholder if your bulb gets hot. 12mm M3 screws for the uprights
Supports used for printing the third upright depending on its slicer orientation.
The shade prints as is, without support and not in spiralize mode.