Summary

Designed a pooper scooper to go on the end of a broom handle, just wrap a poop bag over the end and tie it off, then when you are done pull it off and tie and toss! Printed it at .3 layer and 50% infill for strength but it could probably be printed at 30% just fine.

https://www.youtube.com/watch?v=cnyXT12SNBM

EDIT:

Updated this a bit to version 3, made it thinner, a bit shorter, and changed the angle of the front, also included a smaller version for smaller dogs, the larger one is good for labs and the like, but for smaller ones go for the smaller version.