Summary

Everyone is creating only a LCD front case, what about back ?
Is unsecured board with all the fragile electronics not important ?
I think it is so here is my back panel with hooks to slide in board and put it into the front side of the panel.
Depending on individual requirements, supporting handle/legs will be available as well.
(soon)
Slightly modified front LCD case and back panel (version 1.2)
Quick (Draft) printout of the back (orange PLA)
Attention please:
Back side of the case (version 1.2) fits perfectly but is a little bit too tight.
Version 1.3 is already modified and should fit much better.
Now working on version 1.4 with some clips.