K1C BTT Eddy Mount
Toni Emery
AI로 유사한 모델 찾기
프로필 출력(0)
모델 파일(0)
0
0
0
게시일:2025-12-25 04:02:08
0
0
000설명
태그
모델 소스
리뷰(0)
Created this because I wasn't satisfied with the options for Eddy mounts for the K1C
Only tested on K1C. Unsure about K1 or K1 Max.
Not completely finished. Unhappy with how the overhang prints. But it printed well enough for me to use.
Print 2 washers to insulate the screws from the board.
BOM:
4 - M3x8 BHCS
2 - M3 Nuts
Highly recommend SimpleAF Firmware for the K1
use the default mount
X: -23
Y: 0
태그
모델 소스
원본 링크: 자세히 보기
CC-BY