Loosely based on the PI card deck case by dktosoch on thingiverse (https://www.thingiverse.com/thing:2844013) this is a completely scratch modeled design that incorporates space for an OBDII connector at the rear and a seed studio CAN-FD two channel daughter board.

Designed Raspberry PI model 3 as that's what I had laying around with this hat on it.  I plan to release a model for the 4 and 5 as well. 

Materials:

• Raspberry Pi Model 3
• Seed Studio Can-bus FD Daughterboard
  • https://wiki.seeedstudio.com/2-Channel-CAN-BUS-FD-Shield-for-Raspberry-Pi/
• OBDII 16 pin connector
  • https://www.amazon.com/dp/B083FFTJGN?ref=ppx_yo2ov_dt_b_fed_asin_title
• 4 m2x6 screws
• 2 m2x10 screws

Print standing upright no supports needed.