The pi mount was designed for a simple NAS system based on a PI4 and this Dual HDD/SSD case. The case has an integrated RAID controller, so one drive gets mirrored with out the knowledge of the Raspberry PI and prevent data loss through a drive failure.

I used M2 screws to hold the PI in place and printed the model with the top side down on the bed. On the four legs, there are holes to mount it with screws where you want.

Print Settings

Printer:

Hypercube Evolution

Rafts:

Supports:

Yes

Resolution:

Infill:

15%

Filament:

dasFilament PETG

Black

Notes:

Category: Electronics