Model is a Unicorn head placed on a podium base. Base is approximately 1" in height and the inner diameter is approximately 1/2". This was a quick project for my daughter... it is an end cap to be glued on the end of her baton. Still working on clearing the support trees and deciding how to fit and finish. Designed draft model in SketchUp (unicorn model remixed from original provided by KARE). Adjustments done in Vectary and Fusion360. Sliced with Cura. Used GEEETECH 1.75mm PLA. Print Speed: initial layer 45... then 69. Print Temp: 239 deg. Bed Temp: 65 deg. Fan Speed: 45 Used centric infill 20% and 4 outer walls. Tree supports and raft enabled. Jerk control enabled. This was a simple model, but covers a lot of different settings.