I loved the Vickers gun designed by Jfpion and took the time to assemble it in 3D Builder so I could have it together when printing, so thought others might be able to want it this way, too.

I printed two of these on my Elegoo Mars for my 1:6 scale Camel and they are beautiful. When the barrel is attached to the body it is about 168mm long, with the handle extending to about 182mm. Scale to size as needed.

I also added a small bullet belt, so everything needed is all in one shot.

Elegoo Mars

No

Yes

.05

I printed at .05 layers with AA set at 4 with a combination of light and some medium supports at key points. Do not allow any supports to go inside the barrel, just along outside and at bottom are fine. There are a few spots where you can hollow out, if desired.

Assembled in Microsoft 3D Builder