You have 2 broken tables with 2 missing legs?
Don't throw them away, it may be possible to repair them with a rope and get a slightly higher presentation table for your 3D models as a result ;-)

Inspired by the Impossible Table from Oak600 I developed this impossible repair of two tables with missing legs which look quite normal from the far distance - and cause confusion when you come closer.
.
Update:
I added the FreeCAD file and also recreated this in OpenSCAD to allow you to adapt it to your needs.
You have never customized a thing?
Don't worry, I optimized this thing for easy customization.
You can:
a) Go to "Customize" on this page (directly below the picture) and start the Thingiverse online customizer OR
b) Follow the instructions in the last picture, install OpenSCAD (only 50MB) and customize it with a few clicks there (helps to avoid the waiting time after each parameter change of online customizer)
.

Creality

Ender-3 v2

No

No

0.2

60%

It is important that the legs don't bend too much. Use more wall layers than normal e.g. 5 layers.

Thin enamelled copper wire works best, sewing thread is also OK, fishing line is more difficult to assemble.