A snug little enclosure for a sonoff touch EU. I used this to replace a foot switch for a floor lamp in my living room. This way I can now toggle the lamp by voice while retaining the original manual switch functionality.

You need four M4 bolts to securely screw the switch onto the enclosure.

The enclosure is a tight fit, so make sure you scale it up a bit when printing with a filament like ABS that will shrink. I recommend using some hot glue on the cables to create a strain relief.

I'm using the amazing Espurna firmware by the way instead of the original one by itead which requires their proprietary app.

Print Settings

Printer:

Duplicator i3

Rafts:

Supports:

Yes

Resolution:

Infill:

20%

Category: Household