Work in progress - needs stiffening to reduce vibrations

Pod to mount Shark Byte VTX-S on Switchback Pro

Designed to allow mounting the whoop board inside the very small Switchback Pro. I also wanted to fit a large micro-sized camera/M12 lens inside for better picture quality. Choose between different camera angles - I've only tested the 45deg variant

Printing

• Print in downloaded orientation
• Use Cura Tree Supports
• 0.2mm, 3 walls

Installation

• Cut stack screws down to 21mm to make clearance for the VTX-S mounted to the underside of the canopy.
• Use 4 M2 screws to mount VTX-S
• Place 2 M3 nuts inside hex-cutouts at front mounting holes

Customize it to your liking!

Design is fully parametric - change any number of variables at top of design tree to adapt this to a different frame or camera:
https://cad.onshape.com/documents/75ae699a2132a4132cb4ed0f/w/e0a499b2554ad9ca201badff/e/53e67ceaebb9caa1ed299b68
Create free "hobbyist" account on Onshape to edit:
https://www.onshape.com/en/products/free

Creality

CR-10

No

Yes

0.2

25%