Speed square wall mount with minimal printing effort.

If you own a speed square, chances are you have some pieces of scrap wood with at least one straight edge lying around, too.

This small triangular ledge allows for simple wall mounted storage of a small (cheap) speed square of the eBay or Amazon variety without wasting a lot of filament.

You only need a fairly straight piece of wood (slightly wider and preferably as long as your speed square) to put the wide edge of the square on top and two 3mm woodscrews to fix this triangular print accordingly (done in <30 minutes even with a slow/old printer).

OpenSCAD is not my forte, so please don't mind the very simple scripting.

Print Settings

Printer Brand:

Sovol

Printer:

Rafts:

No

Supports:

Resolution:

0.28

Infill:

Filament: generic PLA doesn't matter

Notes: