I received a set of 16 screwdrivers for Christmas but had no good place to store them. I looked at other pegboard tool/screwdriver holders but they all seemed a little lacking in either the strength of the print or of the pegs to hold it onto the pegboard.

You could also use this to hold any other tool with a shaft, like a scratch-awl, handled allen keys, etc.

This model includes the holder and the pegs which you push from the inside out to attach this to the pegboard. You'll need 12 pegs per holder for best holding strength.

Monoprice

Maker Select Plus

No

No

0.2mm

50%

No supports needed if the holder is printed on it's side. The pegs have a flat side so they print in a strong orientation.

I also had to reduce my retraction distance setting (from 6.5mm to 2mm) to deal with small gaps that showed up in the print between the various holes. Just something to keep in mind with your particular machine.

I designed the holder so that each individual screwdriver section could accommodate a 30mm wide handle. You can see in the photos that this provides a good amount of clearance between each screwdriver. I designed this in Fusion 360, and this was the 3rd iteration of the design that finally worked well.