I was not satisfied with the already available lens-protectors so I made another one. This one is very slim and does not influence the general look of the sight too much.
Meant for the cheap EOTech clones from China (e.g. for Airsoft). I dont know if it will also fit to real EOTech holo sights.
The holder is clamped between the metal outer shell and the inner housing. If it fits too loose, add some black tape on the flat straps to increase the press fit. On my replica it fits very thight and is not getting loose at all, even though it is mounted on a GBB.
Attached is also a template that can be printed out and can be used for adapting a piece of 3mm plexiglas to fit into the slot (cutting + filing needed).

If you enjoy this design and it gives you benefit in your life, consider a tiny contribution to my Paypal. It would be well appreciated. :)
--> Paypal.me/KorbiMuster