I wanted a bit cleaner look for my bear frame, so I came up with these panels. The meanwell lrs 350-24 power supply can be mounted below the panels with M3 bolts. Also I have my Mainboard next to the power supply via a mount and VHB tape. You'll need taller feet though to fit all the wiring.

Also I am using a Switchwire carriage, where the belt holder is a bit off-center. For original Prusa, you might have to mirror the right versions, but I'll need feedback on that.

The panels screw in the frame with M4x8 screws and t-nuts. 

These should be printed in PETG, because PLA tends to warp from the heat from the printbed. The feet I am using may follow if i get around to it.