First things first: this was inspired by this tap handle and it was created in OnShape before I realized that the other model included the part file...

This model is different because:

• It does not require any support material
• There is just enough threading to allow for stability while tightly fitting to a 3/8" screw
• It requires less material as it is thinner (20% infill gives it more than enough strength)
• The fillets on the top and bottom are of different radii to allow for a different finished look

The current stl is threaded for a 3/8"-16 Tap.

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

.2mm

Infill:

Category: Kitchen & Dining