Remixed the case to have a solid bottom and a 3d printed plate. Also included a top bezel for it to "snap fit" together so the bottom of the keys were flush to the top of the bezel to give it a more rounded look (a-la-WizardData Iris Case). You can still use screws though, there are screw holes for both interior and exterior attachment.

Mine in the photos has a switch on the side due to my keyboards using a BlueMicro BLE controller and needs a power switch. The STL's do not have that cut out and are 3 pieces where as mine had to be divided to fit on my smaller printer. If you also have a smaller printer I'd suggest cutting it up yourself so the division is what works best for you.

Print Settings

Printer Brand:

Monoprice

Printer:

Rafts:

Doesn't Matter

Supports:

Infill:

18%

Filament:

Inland PLA/PETG

Rainbow

Notes:

Category: Electronics