I’ve noticed that there are no 3D MC lightswitch models for Europeans. Europe mainly uses rocker switches, whereas the USA predominantly uses toggle switches.

The model is easy to install and doesn’t need to be glued to the wall, even though the wall is damaged. However, that was an older version.

It consists of three parts: two printable and one non-printable. The non-printable part is from a rocker lightswitch and often has a transparent color.

The transparent part will then be placed on the case, on the two shafts.

Painting

You can also paint the lightswitch. In my case, I just painted a sheet of paper and glued it onto the model (the colored model is an older version). It doesn’t look as good as painting directly, but it does the job.

Printing Instructions

• wallcount:     at least 3
• layer height: 0,18mm - 0,2mm