I wanted a latching clip for my rear cover on my Voron0.2. So I designed one that does not interfere with the edge of the panel as the screws in the other snap clip do. There are no fasteners in the back side of the frame.

Use pieces of filament for the pivots.

M3x10 screws fit well.

This will replace one of the small side panel clips and the rear panel clip on one side. You may leave the clips on the other side as is (Spool holder and small clip.)

I printed it in PET-G for the slight flex it will need for the clasp. 

If you need a different panel thickness, please ask. A 2020 version will be here after I start my next build.