I came across the original holder and thought it was ingenious. Detergent leaks when putting the cap back onto the container so we just place it anywhere. We don't have the kind of shelf in the original file plus our shelf is a little high anyway. I measured the screw-on part where the cap attaches onto the container and re-mixed the original in tinkercad to fit over that section.

When attaching, hold it at a 90deg angle (horizontally). Place it over the threads and turn it to it's final position (vertically). It will tighten as your turn it so that it stays in place in it's final position. We use Arm & Hammer 210oz size from Walmart. Enjoy.

Print Settings

Printer:

Prusa Mini

Rafts:

Supports:

No

Resolution:

Infill:

15

Filament: Printed Solid Jessie PLA PLA Mixed Tape #3

Category: Household