It was supposed to be a dice box but the size of it went a bit out of hand, so it can be used either with only hilt and cap to have a relatively roomy dice box (2-3 d&d sets i think) or screwing in as many blade segments as you like to hold a ton of dice or something else. The tip closes the last blade segment, if you want to use the blade it is not necessary to print the cap.

I printed at 0.1 to get the screws right but that depends mostly on your printer, blade and tip should be fine printed empty in case you want to get better transparency, tip and hilt require supports.

Category: Toy & Game Accessories