Cuts spam into 10 even slices (0.3 inches) - the perfect thickness for spam musubi (I created a spam musubi press design, too!). I used 28 gauge galvanized steel wire because that is what available at the local hardware, but stainless steel wire is preferable. You can buy 28 gauge stainless wire on Amazon.

No supports needed with printing as long as you print the bottom piece in the STL current orientation.

Version 2 of the top has a slightly enhanced tie-off, though I haven't checked to make sure it prints okay.

Creality

CR-10S

Doesn't Matter

No

0.2

40%