Stock Paslode case clips tend to fall off and get lost on a job site. Replacements can cost upwards to $20 USD. I copied the design from the original clip and designed in tinkercad.

The clips seem to hold tighter than the original. The original clips have more curvature, I did not wish to follow with that design.

PETG is what I printed mine out of because a hot day could really warp a PLA print and I did not wish to use ABS as it is not as chemical resistant as PETG is.

Support is needed where the hinge overhang is. If the hinge overhang is droopy then the part with not perform well.

The print orientation is as the model is placed.