I wanted to connect a Raspberry Pi 3A+ (with Octoprint installed) to my Anycubic Vyper printer - but I couldn't find any ready-made matching case, so I made this remix.

At first I used a cover with a slot for the tape for the Camera Module V3 - but when summer came, the device started to overheat - so I designed a cover with an additional hole for the fan (30x30 mm) and an input for power connection to the GPIO pins.

Assembly instructions:
The housing is inserted into the frame of the printer - to do this, you need to dismantle the front cover of the frame (unscrew 2 screws).

Fan assembly:
If you use a standard Pi fan (30x30mm) - you can just push it into the lid - it fits quite well. Fan connection - pins 4 and 5 from the attached photo.

Printing instructions:

Printed with 0.4 mm nozzle, 0.2 layer, 15% infill, no supports.

Printed on Anycubic Vyper ;-D