The original seal deteriorated (see photo with the black part), so I designed a new one.

Assembly should be easy and self explanatory. The fit is very tightly over the black rubber main part. You have to stretch the printed part a bit.

For best results, please clean all parts before reassembly.

Printed in sainsmart TPU transparent red.

Print instructions:

• 30% honeycomb infill
• 3 perimeters
• 7 bottom, 9 top layer
• 0.1 mm layer height
• use flex material. I had good experience withe shore 98A, a bit softer could be also good

additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes.
If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.