The Rupee by Ashmonster is a nice looking Rupee, but I had trouble printing it: Printing it flat would result in curled edges, printing it standing on a side with a brim (yes, I tried that) didn't work either: It would tip over at around the halfway mark.

So I created this remix:

It's the standard Rupee .stl but with a secondary file with custom supports. These can be used to print the Rupee standing up and holding on the side.

The custom supports need to be printed "as supports" in Cura and the Support X/Y Distance needs to be lowered to 0.2mm.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

200

Infill:

Filament: purefil PLA

Category: Coins & Badges