needed supports on the top. there is 2 tops mostly the same the 2nd top is a bit taller and i feel works a little better but if your tolerances are not good print the smaller top not the taller one . also the hose adapters are made for a rubber boot to connect the shop vac hose to the connector on the cyclone home depot. and gaskets are also there for the hose connectors and the bottom of the cyclone the bottom is 140mm and the top is 115 on the small one and 145mm on the taller one. hope you like it i have made it and workes well . this is made for 2/12 inch and smaller shop vac just need a smaller adapter thread on the hose adapters are 62mm x 4 pitch

Wanhao

Wanhao Duplicator i3 Plus

Doesn't Matter

Yes

.2

25

needed supports on the top. there is 2 tops mostly the same the 2nd top is a bit taller and i feel works a little better but if your tolerances are not good print the smaller top not the taller one . also the hose adapters are made for a rubber boot to connect the shop vac hose to the connector on the cyclone home depot. and gaskets are also there for the hose connectors and the bottom of the cyclone the bottom is 140mm and the top is 115 on the small one and 145mm on the taller one.

fusion 360