This part replaces the corner clips of the top panel for in order to use a Voron Trident at upside-down stance.

As featured in my video: Link to video follows.

Print four times at Voron recommended settings from PETG or ABS.

(0.2mm layer height, forced 0.4mm line width, 5 top-/bottem solid layers, 40% infill)

Hardware needed:

4x M5x16mm BHCS

4x M5 Hex Nut

8x M3x8mm BHCS

8x M3 hammer head nut

4x compressor feet as specified by Voron Design

Optional: Washers for M5 depending on used compressor feet.

Assembly:
Simply replace the corner clips for the top panel with print parts and hardware.