a complete geodesic dome.

print as in picture so no supports or raft.

but i used a brim with 1 skirt layer and 5 skirl outlines. to help keep it stable. it dont think i even needed a skirt/brim. it just looked so vulnerable.

i used 10% infill but i think it dont need any or u might hav to use more top and bottom solid layers and more outline perimeter shells.

i made this small and it is in inches. this was a test size.

u may want to convert to mm and size it up.

Print Settings

Rafts:

No

Supports:

Infill:

10% or less

Category: Buildings & Structures