Summary

I couldn't find any good label holder on thingiverse so I created one.
I'm using it on IKEA DRÖNA and IKEA STUK boxes.

My goals was:

• easy to print multiple at once - ender 3 fits 58 at once B-)
• not much filament per piece (15g)
• big enough to draw a picture under a text label
• label won't fell off easly when inserted
• no support required

I printed it with PLA on Ender 3, nozzle 0.4 with following Cura parameters:

• just one wall layer
• line width 0.5mm (should work with 0.4)
• infill lines 6%
• temperature bumped to 220 to keep it strong

Label size to insert: 68.5mm x 138.5mm

Note: object prints well vertically. Make sure if slide part is on top!
Note2: Keep elements close to each other, so it can lean on each other.