Bed Mount for Trust Spotlight video camera with universal clamp (up to 1cm bed thickness)
As I can see it may be working with Hama Spy Protect Camera, as the base look the same

UPDATED to version V2

• With more simple design but works much better
• Easier to print
• The clamp is now holding the camera too, not only the mount so no more camera shaking on printer moves

You can use simple claps too (like the ones holding the bad plate).
Then print only 'base_v2' file

The cutted triangles on the base part should be in front of the video camera when assembling
See photos (4,5,6) if you will have some problems:
https://www.instagram.com/p/CVVb9PxNRmA/

---

FIRST version description:
Trust Spotlight Mount.stl is with all parts excluding 'lens cap' (wich covers the lens to protect from damage or dirt when camera is not used)

To unmount a camera just push both sides of mount to center. You can do this even with mount still on bed.

After the print gently unstick the springs (that will hold the camera) from the base. Only the front should be connected to the base.

Partially based on my Universal Bed camera mount

More photos:
https://www.instagram.com/p/CGXkUmRjhkU/

---

Creality

Ender 3

Doesn't Matter

No

It's better to use PET-G than PLA for this.

0.2mm layer hight is sufficient but with 0.1 it will be little stronger.