Summary

I am always tight for space, so I designed this tool caddy to hold the tools I have and use for my Elegoo Centauri Carbon. I've put links to a few of the exact item I purchased so they should fit. (The rest of the tools I already had from my day printing on an old Creality CR-10.) That said, this is a WIP, so verify your tools will work.

I started this project trying to remix someone else's smaller unit, (I forgot where I got it) but eventually just built a new thing. I tried to model/find all the tools to verify fit. The only tool I did not test for size is the holder for the diagonal cutter. Of course, that's the one slot that I'm not happy with. I'd been out of printing for a few years, so my knowledge was obsolete. The model it the size of the ECC side panel, so it is too large to print as one piece with the ECC. Therefore, I split it in two. I also made the Nozzle needle holder slot in so it could be printed separately. I set the Elegoo slicer to PETG, enabled supports -- for the male joint protrusions and screw holes -- and let it do its thing. People with knowledge could probably tweak for a better print.

The existing ECC side panel screws will work, but I swapped for screws 3mm longer.

Anyway, here are the tools I just got for this.

Hex drivers: https://www.amazon.com/dp/B07YKJ1LBJ

Bent needle-nose pliers: https://www.amazon.com/dp/B0D76MG29K?

Diagonal cutter: https://www.amazon.com/dp/B077RTNXVP?

Deburring tool: https://www.amazon.com/dp/B0DYDYKZH8?

I already had the Olfa, ( https://www.amazon.com/OLFA-5019-Stainless-Auto-Lock-Utility/dp/B0006O87O6/ref=sr_1_2?) digital vernier caliper, scraper, (Creality) Nozzle nut driver, and Tweezers. The rest came with the ECC.