Updated seat to use latest pla snap connector e connector. Also added a top. The top has a slot where you can slide in a window film.

This is a seat / cockpit for your 3.75 inch / 1:18 scale action figures. Even action figures get tired of standing! It has holes and connectors that are intended to connect to either more of this same item or eventually others as well.

Seat prints OK with no supports. No special printer resolution required, although the buttons will look better at higher resolutions. Note the attachments in the middle for a rubber-band seat belt. This is to keep the pilot in the seat even while upside-down!

This is meant to be just a beginning, not an end! Some design principles I will try to follow:

• no glue required
• modules may be connected / disconnected by hand with no screwdriver or additional tools required
• allows for many different combinations to allow you to easily create your own unique constructions
• not too many parts per module (usually just 1!)
• emphasis on fun and playability, and where possible, durability
• may have some similarities to but will not be exact copies of existing ships / vehicles from past popular sci-fi tv shows and movies

My other Planetary Explorer Module designs all interconnect with this one, to see even more please visit https://petrusmono.com/pems

If you need some vintage action figures to put in these designs, please visit my ebay site here: https://www.ebay.com/usr/phat_mick

If you need a vintage action figure to put in the seat, I have some here: https://www.ebay.com/usr/phat_mick

Prusa

I3 MK3S

No

No

15%

Put action figure in seat and enjoy!

Used Tinkercad.