I wanted to use one of my Raspi Zero W as am Octoprint Camera and eventually also as an Octoprint Server.

But I didn't find a case for the Zero W with the new V2.0 Camera.

So I designed one and would like to share it with you!

After successfully using this webcam clip on my Anycubic I3 mega X

https://www.thingiverse.com/thing:2931900

I decided to use the same arms for my smaller Anycubic I3 mega S.

To do so, you just have to cut off the upper part of the c270_support and drill a 6mm hole for the additional camera holder.

Anycubic

All-metal Mega

Doesn't Matter

Yes

0.2

20%

Supports are only needed for the holder not for the case.

The 4 screws are 2mm Diameter 7mm long.

If you want to use the holder on the case support or on a tripod then you have to cut a 6mm thread in the bottom hole of the holder.